The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and changing the cover can be a lot harder.
Getting a new swim spa is an amazing occasion in life. You’re anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have lastly made a selection from the different designs you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a 4 area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence since as quickly as it is placed in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely little as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.

It takes place gradually and on a Swim Spa Cover which is made of private areas, at differing speeds. So ultimately you’ll discover a couple of of the areas are truly getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still need to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com developed a different style for their Swim Spa Covers
Instead of using numerous foam panels to build Swim Spa Covers that will ultimately wind up in some land fill, they created one that uses air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this website so you can discover it again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *