The Challenges to Swim Spa Covers

Swim Spas represent distinct difficulties when it pertains to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re eagerly anticipating the exercise you’ll obtain from using it. Maybe you’re a little relieved to have finally selected from the different designs you looked at. At any rate, you most likely weren’t believing much about the cover you would use.
Usually, the cover that gets home with your brand-new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Built in obsolescence because as soon as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely little as they rise from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It occurs gradually and on a Swim Spa Cover which is made of specific areas, at varying speeds. So eventually you’ll discover one or two of the sections are truly getting heavy. The bar lifters on completions of the swim spa aren’t much help since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com came up with a new style for their Swim Spa Covers
Instead of using a number of foam panels to develop Swim Spa Covers that will eventually wind up in some landfill, they developed one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to purchase today, bookmark this website so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *